the minimoog synthesizer operation manualmoog MUSIC INC. Academy Street (P.O. Box 131) Williamsville, NY 14221
modifiers The Modifiers section of the front panel features controls for the two sound modifiers, the Filter and the Loudness Contour, which respectiv
TIME control from left to right. You will hear the brightness of the note increase sharply at first, and then more gradually as the attack time increa
attenuated. To observe the effect of these switches, turn off Oscillator 1 (C) and the Filter Modulation switch (J), and set control (17) to 0. Turn
loudness contour The volume of the audio signal which passes through the Modifiers section of the Mini Moog is contoured by the Loudness Contour contr
STANDARD ACCESSORIES SHIPPED WITH MINI-D SYNTHESIZER 1. Mini brochure & 1971 Catalog 2. Mini Instruction Manual 3. Warrantee (Reg. Postcard) 4. Sh
OPTIONAL ACCESSORIES NOW AVAILABLE FOR USE WITH MINI MOOG MODEL D1. 958 FOOT PEDAL This controller can be used to control the volume of the output, pi
S-TRIG PLUG FOR MINI MOOG MODEL D When inserted, this plug keeps the contour generators "on" continuously. It can be wired to an accessory
LEFT HAND CONTROLLEREXTERNAL CONTROL OF GLIDE AND FINAL DECAY. The rocker switches in the left hand controller section have replaced the momentary pus
Mini Moog Model D Back Panel Adjustments (on instruments with serial number 1237 and higher) As with any fine musical instrument, the Mini Moog may r
8. Turn off reference oscillator. 9. Set OSCILLATOR 1 to 2´ range. 10. Turn on OSCILLATOR 2. 11. Tune OSCILLATOR 2 to OSCILLATOR 1, using OSCILLATOR 2
A GUIDE TO THE OPERATION OF THE MINI MOOG MODEL D contentsintroductionbasic mini moog featuresaudio, control, and timing signalssetting up the instrum
basic mini moog features The Mini Moog contains the basic components and features to be found on larger, studio-oriented synthesizers. Its five sound
setting up the instrument Place the instrument at a convenient level for playing and secure the Front Panel in the "up" position by means of
output section The Output section of the front panel includes two basic switches: the POWER switch, which turns the instrument on and off, and the MAI
oscillator bank This group of circuits contains three separate and independent oscillators. Each oscillator produces a waveform which repeats regular
controllers This section will demonstrate the use of the controls located to the left of the Oscillator Bank (used in tuning and setting up a sound),
9. Before continuing, defeat the oscillator modulation by turning off switch (A). other controllers10. The PITCH wheel (28), located next to the MODUL
mixer Audio signals produced by the three oscillators, noise source, and microphone preamplifier are combined and balanced by the Mixer section’s swit
Komentáře k této Příručce